Profoto 250 W Guide de l'utilisateur télécharger pdf (Page 17)

Profoto D1

www.profoto.com

Maintenance

Changing flash tube and/or modeling lamp

1. Ensure that the D1 unit is turned off and that the power cable is not connected.

2. If the unit has been in use, wait five minutes to allow the unit to be fully discharged.

3. Gently remove the frosted glass plate.

4. Change the flash tube:

• Unlocktheflashtubetriggerbyunfoldingthestainlesssteelribbonsaroundthe

clasp.

• Grasptheflashtubeinthebottomandpullitstraightoutofthesocket.

• Wheninsertingthenewflashtube,ensurethatthetriggerconnectionclasps

properly around the flash tube.

• Locktheflashtubetriggerbyfoldingthestainlesssteelribbonsaroundthe

clasp.

5. Change the modeling lamp:

• Pullthelampstraightoutofthesocket.

• Insertanewmodelinglamp,straightintothesocket.Donottouchthelampwith

bare hands.

6. Carefully fit the glass plate in place, with the frosted side inwards. Make sure that the

safety pins fit properly around the glass plate.

Clasp

Flash tube

Modeling lamp

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Pas de commentaire

Profoto 250 W Guide de l'utilisateur Page 17