BatPac
10
www.profoto.com
Functionality
Battery
Only charge the battery using a standard Profoto Battery Charger 2A. For a long battery
life, the battery shall be charged as often as possible and preferably before the battery is
fully discharged. The battery shall be fully recharged prior to storage. It is no problem to
charge the BatPac continuously with the Profoto Battery Charger 2A (during storage). The
BatPac can also be charged while in use.
The capacity of the battery decreases dramatically when the battery temperature falls
below freezing 0 °C (+32 ºF). For optimum performance, try to avoid using the BatPac for
longer periods at temperatures below freezing 0 °C (+32 ºF).
Defective batteries shall be returned to the dealer for recycling. For details about the
battery, see section Technical data.
Battery Low Indicator
The Battery Low Indicator [3] indicates the battery voltage level. When the battery level is
low, the Battery Low Indicator [3] will light up in red. If the Battery Low Indicator [3] starts
to illuminate during flash recycling, the battery should be recharged.
Power On/Off
The On/Off Switch [4] is used to switch on/off the BatPac. When the Bat/Pac is switched
on, the Power On Indicator [2] has a steady green light.
Battery Switch
The key to the Battery Switch [7] shall be turned clockwise when the BatPac shall be used.
During transport and storage, the key to the Battery Switch [7] shall be turned counter-
clockwise and removed to avoid discharging of the battery.
Over Temperature Indicator
The Over Temperature Indicator [5] indicates the internal temperature of the inverter. If the
inverter overheats, the Over Temperature Indicator [5] will have a steady red light and the
output power will automatically be disconnected.
Ground Fault Circuit Interrupter (GFCI)
The BatPac has a built in Ground Fault Circuit Interrupter (GFCI) which shuts down the
output in case of short circuit to the chassis in either the BatPac or in the connected device.
If the GFCI is activated the Battery Low Indicator [3] will be lit and the output shut down.
The BatPac is reset by turning off and on the BatPac .
Attention! If the GFCI is activated, that is an indication of an error which is potentially a
safety hazard. If the GFCI always activates, contact your nearest Profoto service station
for check up and repair.
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels