Profoto Acute2 manual Guide de l'utilisateur télécharger pdf (Page 7)

BatPac

www.profoto.com

System description

The BatPac is a combined inverter and battery unit, integrated in a special purpose bag

The BatPac is available in two versions, with outlets for 120V or 230V. The maximum power

for both versions is 600 W.

Features:

• Switching mode design

• High efficiency, low harmonic distortion

• Pure sine wave output voltage

• 12 VDC input and 120VAC 60Hz or 230 VAC 50Hz output

• Power On Indicator (LED)

• Battery Low Indicator (LED)

• Over Temperature Indicator (LED)

• Battery switch

Protection:

• Input low voltage

• Input over voltage

• Battery Low Indicator

• Over Temperature + Shut Down indicator

• Ground Fault Circuit Interrupter (GFCI)

• Short circuit (by fuse)

The BatPac is compatible with the following Profoto products

• Profoto D1 (all models)

• Profoto Acute2 (all models)

• Profoto ComPact (all models)

The BatPac can also be used for any peripheral equipment, such as camera chargers, PC,

wind machines etc. However, this equipment should not be connected to the same BatPat

as a flash generator.

1 For a list of compatible products and specific performance with Profoto products see section Product

compatibility and following sections.

2 Always check the manual or ask the manufacturer of the peripheral equipment if it is possible to power it by an

inverter before connecting it! The BatPac is able to power loads up to 600W. Do not connect devices with a higher

load! Profoto can not be held liable for any damage caused to peripheral equipment when used with BatPac.

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Pas de commentaire

Profoto Acute2 manual Guide de l'utilisateur Page 7