Profoto Acute2 manual Guide de l'utilisateur télécharger pdf (Page 19)

BatPac

www.profoto.com

Trouble shooting

Symptom Diagnose Action

No output voltage, Power

On Indicator [2] not

illuminated

Bad connection to the battery. • Check the cable connection to the Sealed Lead

Acid Battery [19].

Internal fuses defect. • Check Fuses [17]. If it still does not work after

replacing fuses, contact your nearest Profoto

service station.

No output voltage, Over

Temperature Indicator

[5] illuminated.

The BatPac has been

overheated.

• Switch off the BatPac and the power

consuming unit(s).

• Wait for approx. 5-10 minutes and switch

on the BatPac only (disconnect the power

consuming unit).

• Reduce the loading and ensure better

ventilation.

• If this is a frequently repeating problem it

may be a problem with the internal fan of the

BatPac. Contact your nearest Profoto service

station for guidance.

No output voltage,

Battery Low Indicator [3]

illuminated.

The GFCI has been activated. • Potential safety hazard! Leave the BatPac and

the connected unit to your nearest Profoto

service station for check-up and repair.

Battery Low Indicator [3]

is illuminated.

Battery voltage is too low. • The battery must be recharged.

The connected device

doesn’t work properly

or at all.

Energy consumption is too

high (more than 600W)

• Disconnect the power consuming unit,

if possible use a unit with a lower power

consumption.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Commentaires sur ces manuels

Pas de commentaire

Profoto Acute2 manual Guide de l'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Lampes de travail Profoto Acute2 manual